Operating Instructions

ESC 400 Control

ESB 210 Control

All Winches

All Slider Types

ESC 300 Control

ESC 200 Control

All Cleaning Robot Types

All Engine Types

FAQ: Controls

ESB200, ESB210 + ESC200 Reset System

ESB210 + ESC200 Motor Current Display - Motor Diagnosis

ESB210 Voltage Monitoring Deactivation

ESC300 Voltage Error E13

ESC300 Change Radio Channel

ESC300 Motor Current Display - Motor Diagnosis

ESC300 Emergency Operation

ESC300 Reset Radio Channel

FAQ: Plant Operation

DRUM REPLACEMENT FOR A SINGLE WINCH

RETROFITTING FROM CONCRETE TO RUBBER FLOOR

There is a retrofit kit for welding, which allows conversion from concrete to rubber flooring. This includes widenings on the central support and base support as well as the corresponding recess for the U-guide.

GEAR MOTOR: OIL QUANTITY AND TYPE

Quantity in liters:

  • ABM 0.55 kW 1.2
  • ABM 0.75 kW 2.8
  • Himmel 0.55 kW 1.3
  • SEW 0.75 kW 5.9

 

Recommended oil type:

  • ABM ARAL Degol BG 220
  • Himmel/SEW CLP VG 220 mineral

INSTALLATION OF A U-GUIDE

SLIDER STANDS STILL IN COLD

Slider, wire rope, and/or idler pulley frozen

-> Make parts functional again
-> Activate frost protection program in time

WINCH RUNS HARD

Probably shaft seal between gearbox and electric motor leaking. Noticeable if the motor is oily.

CLEANING FLAP DOES NOT GO UP ANYMORE

Scraper shoes are worn and/or scraping plate is too short

Rope Change

Defective rope must be unwound at a slow speed. When rewinding, it must be ensured that the first layer of rope is neatly wound onto the drum.

CORRECT ATTACHMENT OF PLASTIC ROPE

ROLLING OFF PULL ROPE CORRECTLY

ATTACHING RUBBER STRIP TO SCRAPING PLATE

CREATING A ROPE LOOP

Contact us if you haven't found a solution here

Call us or fill out the contact form. We will get back to you as soon as possible.

Kontaktinformationen
Sind Sie bereits Kunde bei uns?